Rick;

	I would like to ask you to have Jed go over to manufacturing today
and to instruct them on what voltages should be used to test the PCBs for
low and high Vcc.  They are currently using 4.9 and 5.1 but I don't think
that is good enough.  Please see Bob Stewart or Jim Freitas.

	We are shipping three games to Japan tomorrow and we need to test
these PCBs as soon as possible.

	I also do not know where they are reading the voltage on their test
fixture.  It could be at the power supply rather than the worst place on the 
PCBs.

	Please let me know what instructions you have given them and the 
results of your visit.

						Thanks