Rick Meyette says that he was able to get Steel Talons to pass the FCC test
as of about 3PM today. Changes include:
	1) Metal Standoffs between PCBs (Jed said that official release 
					  documentaion has always specified 
					    metal stand-offs...)
	2) Filter caps on DSIII - I believe Rick said he would supply input
	     to PCB design - I did not ask him to do it one way or the other.
		This is up to Jed.

	3) Beads on Harness(es) - I did not ask how many.

Rick says the cabinet will be move to the ID common area since they are
anxious to get it.

I know about the caps to be added to the DSPCOM Board. Does the DS III 
need caps, too?

Jed

The caps have to be added to the DSPCOM PCB -- NOT -- DSIII PCB as stated
previously. 
......................... previous message ..................................

From:	KIM::DOWNEND      13-JUN-1991 16:24:12.76
To:	LOGG, MARGOLIN, MONCRIEF, ROTBERG, MCNAMARA, MCCARTHY, MOORE, BENZLER,
CC:	LEON, DOWNEND, TAKAICHI, HATA, LANDAVERDE
Subj:	Steel Talons FCC Test
Rick Meyette says that he was able to get Steel Talons to pass the FCC test
as of about 3PM today. Changes include:
	1) Metal Standoffs between PCBs (Jed said that official release 
					  documentaion has always specified 
					    metal stand-offs...)
	2) Filter caps on DSIII(WRONG: should read DSPCOM) - I believe Rick 
             said he would supply input
	     to PCB design - I did not ask him to do it one way or the other.
		This is up to Jed.
	3) Beads on Harness(es) - I did not ask how many.
Rick says the cabinet will be move to the ID common area since they are
anxious to get it.